What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 00:42

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The other is “what does a “fuse” do?”
eight
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What does a fuse do?
Has a cop ever said something to you which was completely unexpected?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–10[John johnson John Johnson ]
But… the neutral is now “floating” because of the 1 ohm resistance.
What are the withdrawal symptoms of Klonopin 1mg?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
I post the exact comment here.
One
Broadcom CEO On VMware Renewals, VCF Customers And Tomahawk 6 - CRN Magazine
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
One is “what exactly is in a ‘surge protector’ ? ”
Murder, Sexual Assault, And Massive Fraud: 15 Celebrities Who Are In Jail For A Long Time - BuzzFeed
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
CVS closing 271 stores, including 3 locations in Upstate NY - Syracuse.com
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
He then describes Rainy Season and Lightning.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
These are simplified answers to the original question, and does not change anything I wrote above.
It seems Mohan does not understand the difference between a comment and an Answer.
Upvotes:
Scientists Stumble Upon The World’s Oldest Stomach Stone Fossil - The Daily Galaxy
[image of Common-mode choke]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The third is lightning and “how it gets conducted into a home.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
There are three different concepts here that are getting confused.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
the problem then depends on "how fast does the fuse operate?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Dementia Risk Declining With Each Generation, Says Promising New Study - ScienceAlert
This is where the MOV conducts again, and dissipated the energy.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
For this case there are devices called Metal oxide varistors (MOV).
Scientists Just Found an Ingredient for Life in a Newborn Planet System - The Daily Galaxy
nine
What is lightning?
[old diagram got deleted by accident]
what exactly is a ‘surge’ protector?
(Dc diagram shown, AC is similar).
At least they know the answer if they wanted it.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
First Sentence:
It also is a device that limits the change in current flow.
The bolt then partially travels down the line to your home.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
An AC voltage/ current source, and an ac inductive load.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but this device (an Inductor) … impedes the rapid changes in the current.
The MOV will conduct when the voltage exceeds 50% of line voltage.
But it can get overloaded, and no longer works.
Here is a simplified AC power diagram.
This is 'the assistant's answer'
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is where this question deviates from being a 'generic' question, and becomes more specific.
He then asserts :
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
a photo is worth a thousand words.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
A circuit breaker is similar, but is resettable.
This one hit behind the barn.
so, what happens?
So, the voltage could go up to 500 volts, and the fuse will not open up.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
but I think this circuit , shows a few more pieces.
Barnstars:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Because the load is inductive, the current lags the voltage.(by a bit).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
In schematic diagrams this is the symbol for a fuse:
He then describes the function of a fuse.
These devices are installed between the “hot” and “neutral” and protective ground.
There are two important concepts here.
2024–10–16 [ OO OLAOYE OYEBODE ]
This device then solves the entire problem.
Edit 2024–10.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
A fuse is a non-resetable over current circuit protector.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".